C8 Corvette Lowering Springs by HYPERCO - 1 INCH
C8 Corvette Lowering Springs by HYPERCO - 1 INCH
📷
By starting work early on with Hyperco, Paragon Performance helped create a lowering spring option for the C8 Corvette cars with Mag Ride, and with or without front lift.
LOWERS 1 INCH ON ALL C8 CORVETTE CARS
The lowering spring kit offers 1 inch of lowering front and rear. Combine that with the factory adjust-ability of .75 inch lowering on Z51 cars you can achieve a total lowering of 1.75-2 inches on the Z51 cars. The spring is also 30% stiffer than factory giving increased handling without sacrificing low speed ride comfort. Cars that have front lift can use these springs and our lowering collars up front to achieve the same drop.
These have been specifically engineered to work with the factory shocks. Using 3D scanning technology the entire suspension was scanned, measured, and studied. This resulted in a spring that works with the factory shocks to maintain correct geometries while lowering the vehicle and increasing handling. Anything beyond what these springs offer would require an entire new set up, much like aftermarket coilovers.
- Fits all C8 Corvettes - (Base, Z51, Front Lift, Mag Ride - All verified @ Paragon )
- Smooth ride
- Mag Ride functions like factory
- Front Lift still functions like factory
- 1 Inch of lowering
- Z51 cars can achieve a full 1.75-2 inch drop if they choose via OEM lowering spring perch or by using our lowering collars for front lift cars.
- 30% stiffness increase over stock
- Powder Coated Black for OEM like look
- Fatigue tested 140,000 jounce to rebound cycles with no issues.
- Made in USA
- Lifetime Warranty
- Works with Paragon front lift lowering collars
- Works with Paragon 20mm spacers
* cars with all 3 ( lowering collars, 20mm spacers, and springs ) will need to run front camber of -1.5 degrees.
Photos Below: Lowering collars (same for Z51 cars who have lowered via spring perch) + Lowering Springs + Wheel Spacers + -3 Camber (track alignment)
📷
📷
📷
📷